Air-suspension P-2426 Manuel d'utilisateur télécharger pdf

Hummer H2 Compressor Hose & CPU Install Guide

Rev-01 06-07-10

1. Locate and unplug your ECU module from your

old compressor. The module is located to the side of

your compressor assembly.

2. After unplugging the module, slide it forward and

unclip it from the old compressor assembly. Install

your old module in reverse order onto the new unit.

3. Remove the shipping plugs from the new

compressor. There are 3 black caps over the exit

ports, and 2 red caps over the intakes.

4. Install the 2 smaller hose assembly onto the valve

block and tire inator exit port.

5. Install the single small hose in right side of the

valve block. This hose has a red mark on the end.

6. Install the dual intake hose assembly into the

ports on the top side of the compressor.

P-2400 & P-2426

Hummer H2 Compressor Hose & CPU Install GuideRev-01 06-07-101. Locate and unplug your ECU module from your old compressor. The module is locate

Modèles reliés P-2400

Pas de commentaire