Air-suspension Front and Rear Coil Spring Conversion LINCOLN Mark Manuel d'utilisateur télécharger pdf (Page 3)

9. Carefully remove old air strut from suspension.

10. Unhook upper control arm from the front wheel spindle. (Remove upper spindle to ball joint bolt and nut.

Slightly spread spindle at slot and remove ball joint from upper control arm.)

11. Position and fasten the three upper studs through shock tower, and loosely assemble the three nuts and

collar. (Refer to step 7)

12. Place lower end of the strut over lower suspension arm and loosely assemble with nut and bolt. (Refer to

step 8)

13. Tighten three upper nuts. (Refer to step 11)

14. Attach the spindle back to the upper control arm. (Refer to step 10)

15. Tighten the lower shock absorber nut. (Refer to step 12)

16. Hook height sensor back to upper control arm. (Refer to step 4)

17. Replace wheel and lower vehicle.

1 2 3 4 5 6 7

Pas de commentaire

Air-suspension Front and Rear Coil Spring Conversion LINCOLN Mark Manuel d'utilisateur Page 3